Edgebander 300

The EB300 Series is a heavy-duty edgebander which is simple to operate and complements woodworking shops both large and small.

Standard Features
Touch screen control
Teflon coated glue pot, easily accessible and easy to clean
Pneumatic guillotine
Four pneumatic pressure rollers at gluing station
Twin end trimming unit
Top and bottom trimming units
Top and bottom scraping units
Corner rounding unit
Buffing units
Interior lights
Manual beam rise and fall
Telescopic panel support of large panels
Heavy-duty chain with replaceable pad
Mechanical digital readouts to all movements
Extruded top pressure beam
CE approved electrics
Simple set up and changeover
Air regulator, filter and lubricator

General Specifications

Panel Width, min:
2 3/8 in (60 mm)*
Panel Size, min:
12” x 2/3/8” (300 x 60mm) or 6” x 6 “ (150 x 150 mm)
Panel Thickness, min - max:
½ in (12 mm) – 2 3/8 in (60 mm)
Edge strip thickness:
1/32” (0.4 mm) – 1/8” (3 mm)
Feeding Speed
2 speeds, 40 ft/min and 65 ft/min
Air Pressure:
87 psi
Total Power:
17 hp (14.55 kw)
460v 3 ph 60 Hz
2,860 lbs (1,300 kg)
Overall Size:
155” x 33” x 64” (3,938 x 830 x 1610 mm)

for Machine Specifications

Control – Touch screen control with a very simple interface allow the operator to simply run the machine. Glue temperature digital display shows when it is ready for operation. Power on, heater and lamp switches, as well as E-stop centrally located. Error information will be displayed on the touch screen to help troubleshooting.

Automatic Feed Table – Easy introduction of material into the edge banding process. Up to 3mm thick edging.

Glue Station – Glue pot with integrated heater, conveniently located for easy access. Under average temperatures the glue heat up is approximately 15 minutes.

Synchronized Feed – Allows the edge banding tape to be fed consistently to the surface of the material. The rotating drive runs at the same speed as the feeding belt, ensuring no missed edges and therefore no need for re-work. This feature is normally reserved for higher end models, but at Nextech we feel this is a compromise in quality we are not willing take.

End Trim – After applying the glue and the tape to the edge, this double motor unit trims both ends accurately and with an excellent quality cut.

Top and Bottom Trim – Double motors, both sides get trimmed to a perfect fit.

Corner Rounding Unit – 2 motors 0,37 kW each, 12.000 rpm for rounding corners of thick PVC/ABS edges, in a single pass, on straight profile panels and post-formed panels at 90° and 180°. The profile form is directly copied from the work-piece by a tracing roller and transferred to the trimming cutter. Vertical and horizontal copying system. Adjustable cutting position by mechanical micro-metric indicators.

Scraping Unit – Individual independently moveable scraping units with digital readouts to each movement.

Buffer Station – The last process is two buffing wheels for a smooth and high quality surface.

Heated Guide Fence – Heated fence will help to glue adhesive to cure faster by warming the material edges before the panel is fed into the machine. This feature is normally reserved for higher end models with other manufacturers, but at NexTech we feel is an important option at any level.

Electronics – The electrical panel is clearly marked and easily accessible.

For more information on our quality machines and great prices